If the printer contains a SIMM memory board, switch the printer off. Replacement kits for these rollers are easily obtainable and can solve the problem. Problems such as paper jams can be fixed by replacement of pickup rollers located under the toner cartridge, replacement of the fuser door, checking if the paper separation paws are not bent, and replacement of the delivery rollers. Continue will not clear the display. If you are on a network, contact your network administrator. If any of these error appears, press Continue to resume operation.

Uploader: Kajigis
Date Added: 8 June 2012
File Size: 32.96 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 96208
Price: Free* [*Free Regsitration Required]

Check the printout for loss of data or print quality. A temporary error occurred while printing. This error most commonly occurs when the paper size knob on the or sheet universal cassette does not match the installed paper, the wrong size lasdrjet is loaded into a cassette, or the printer picks up two sheets of paper at once.

For network MIO cards, this means there was an abnormal connection break. Remove the accessory cartridge, clear any pending error conditions, then re-insert the cartridge.

See the user’s manual for the MIO card.

This is not a feature of the original Laserjet 4. If the SIMM device has more than one bank of memory, the good banks will be configured.

HP LaserJet 4

These models also feature a W power saving stand-by mode, oaserjet was not included in the original Laserjet 4. If any of these errors appears, switch the printer off and then back on.


It prints eight pages per minute, and the user cannot extend the feeders. Because the printer uses the MP tray as both a manual feed tray and a paper cassette, manual feed works differently than for laseruet LaserJets.

If the error message does not appear, the problem is in the SIMM.

HP LaserJet 4v Specs – CNET

Insert the accessory cartridge, clear any pending error conditions, then remove the cartridge. An alternative is to enlarge the roller slightly by using heat shrink over the output rollers. Shake the toner cartridge or replace it. Remove the page from the output bin and press Continue. Switch the printer off and then back on again. In many cases, the delivery rollers upper and lower in the upper or final stage of the paper exit are worn or unserviceable.

Switch the printer off, then back on. Paper Is jammed in the paper path or the paper jam sensor at the rear of the fusing assembly may be stuck causing a false paper jam warning. SIMM Slot 1 2: The printer should operate normally, but call your dealer or HP service representative. If the error is still present, first verify that the SIMM board is correctly installed.

HP LaserJet 4v, 4mv Mono Laser Printer

If the error appears again, record the numbers following the error message and call you dealer or HP service representative. If the error continues, call your dealer or HP service representative. Switch the printer off and then back on.


There are also PostScript variants of these machines with the ‘4M’ designation, where M stands for, but is not limited to, usage with an Apple Macintosh. If you reset the printer press Reset to immediately activate your selections, you will delete temporary macros, temporary fonts, and buffered data. While clearing paper, the top cover or the rear laserjett must be opened and closed again before pressing Continue or On Line to resume. Check that the rear cover is closed; laserjett open rear cover may cause a paper jam.

HP LaserJet 4v Printer| HP® Official Store

Verify that the SIMM board is installed correctly and switch the printer back on. SIMM reporting information incorrectly 8: Press Continue to resume printing. This page was last edited on 26 Septemberat Press Continue to print the transferred data, then simplify your print job or install additional memory.